LIGHTING BURNERS – simply press the knob in, turn anti-clockwise to maximum, the electronic
igniter will spark and ignite the burner. Check that the gas has been lit; if the burner fails to
ignite repeat the above process.
For models with Flame Failure follow the above procedure but keep the knob fully depressed for up to
10 seconds after ignition to allow the safety to lock in. Check that the gas has been lit; if the burner fails
to ignite repeat the above process. If the burner still fails to ignite, a match or lighting device can be used,
but care must be taken. Keep igniters dry. If the problem persists, contact Eurolinx Pty Ltd or their
appointed agent for service.
DO NOT TOUCH HOT SURFACES, ALLOW HOB TO COOL BEFORE WIPING SPILLAGE.
To Next Page
Loading...
Need help?
General
