ILVE ILO69DCX - Accessories

EN - 1
2. Adjust the time while
the dot is flashing
using the “+” and “-”
keys.
3. After a few
seconds, the dot will
stop flashing and will
remain illuminated.
Key Lock
The key lock automatically activates
after the timer has not been used for 7
seconds. “ ” symbol will appear and remain
illuminated. To unlock the timer buttons,
press and hold the “MODE” button for 2
seconds. The desired operation can then be
carried out.
Audible warning time adjustment
The audible warning time can be set to any
time between “00:00” and “23:59” hours.
The audible warning time is for warning
purposes only. The oven will not
be activated with this function.
1. Press “MODE”. The
symbol “ ” will begin to
flash and “000” will be
displayed.
2. Select the desired
time period using the
“+” and “-” keys while
“ ” is flashing.
3. The symbol “ ” will
remain illuminated, the
time will be saved and
the warning will be set.
When the timer reaches zero, an audible
warning will sound and the symbol “ ” will
flash on the display. Press any key to stop
the audible warning. Press “MODE” for 2
seconds the “
” symbol will disappear and
the clock will be displayed.
Semi-automatic time adjustment
(cooking period)
4.3 Accessories
The EasyFix Wire Rack
Clean the accessories thoroughly with
warm water, detergent and a soft clean
cloth on first use.
T2
5
4
3
2
1
T1
• Insert the accessory to the correct
position inside the oven.
• Allow at least a 1 cm space between the
fan cover and accessories.
• Take care removing cookware and/or
accessories out of the oven. Hot meals
or accessories can cause burns.
• The accessories may deform with heat.
Once they have cooled down, they will
recover their original appearance and
performance.
• Trays and wire grids can be positioned
on any level from 1 to 5.
• Telescopic rails can be positioned on
levels T1, T2, 3, 4, 5.
• Level 3 is recommended for single level
cooking.
• Level T2 is recommended for single
level cooking with the telescopic rails.
• The turnspit wire grid must be
positioned on Level 3.
• Level T2 is used for the turnspit wire
grid positioning with telescopic rails.
****Accessories may vary depending on the
model purchased.