Inse rtth e drainh ose into a drain pi pe with a m inimum diameter of 4cm, orlet it r un into th es ink, making su re to
avoid bending or crimping it. Use the special plasticsupport that comes with the appliance . The top ofthe hose
must be at a heig ht b etween 4 0 an d 1 00cm. The fr ee end o f the hose must no t b e im mersed in wat er t oa void the
back f lo w of i t.
φ
40mm
A
Counter
Front
Drain pipe
NOTE
Thetopofthehose
must be at a height
between
40 and 100cm.
The free end of the
hose must not be
immersed in wa ter .
B
Ahose that attaches toa sink spray canburst if it is installed on the same water line asthedishwasher. If your sink has
one, it i s rec o m men de d t het t he hose be di sc on ne cte d and the h ol e plu gge d.
Pull The safety supply hoses completely out from storage compartment located at rear of dishwas her.
Turn water fully on before starting the dishwasher.
1
Tighter the screws of the safety supply hose to the faucet with thread 3/4inch.
The sa fety su pp ly hos e co nsis ts of the double wa lls. T he ho se's syst em guar an te es i ts i nterventi on by b lockin g the
flow of water incase of the supply hose bre akingand when the air spacebetweenthe supply hose itself and the outer
corrugated hose is full of water.
Turn off the water.
Release the water pressure by depressing the pressure release button. This relieves water pressure and protects you, and the
room, from severe splashing.
Unscrew The safety supply hose from the faucet..
3
2
1
2
3
Th e appli ance mu s t be c onn ec ted to the wa ter m ai n s us i n g n e w hose- se t s .
The old hose-sets should not be reused.
Wate r pr essu re m ust be b etween 0,04 MPa and 1 M Pa . If t he pr essu re i s be low the m inimum
consult o ur S ervic e D epa rtment fo r ad vice.
Connect the cold wate r su pp ly hose to a t hreade d 3/4(i nch) c onn ecto r and make su re t hat i t is fa stened t ightly in place.
If th e wa ter p ipes are new or have n ot b een used for an e xtended peri od o f time , let the wate r ru n to mak e su re th at th e
water is clear and free of i mpurities . If t his p reca utio n i s not ta ken, the re is a ris k th at t he water i nlet can g et b locked
and damage the a ppliance .
To Next Page
Loading...
