The dishes were not
loaded correctly.
See notes in " Loading the Dishwasher Baskets ".
Select a more intensive programme.
See" Wash Cycle Table ."
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay can rotate freely.r
Clean and/or fit the filter combination correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms".
r
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Re-loading the dishes properly.
Load th e dishwasher as suggested in the directions.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishe s are barely warm to the touch. Empty the low
bas ket fir st. This prevents water form dropping off
dishes in the upper basket.
In short program the washing temperature is lower.
This also lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more difficu lt with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The programme was
not powerf ul enough.
Not enough detergent
was dispen sed.
Item s are blocking
the path of sp ay arms.r
The filter combination
inthebaseofwash
cabinet is not clean or
is not correctly fitted.
This may cause
the sp ay arm jets
to get blocked.
r
Combination of s oft
water and too much
detergent.
Aluminum utensils
have rubbed agai nst
dis hes.
Dishes block
detergent cups.
Improper loading
Too little rinse -aid
Dishes are removed
too soon
Wr ong program
has bee n selected
Use of cutlery with
a low-quality coa ting
Overflow.
Whe n some malfunctions come on, the appl iance will display error codes to warn you:
Longer inlet time .
Faucets is not opened, or water intake is
restricted,or water pressure is too low.
Som e element of dishwasher leaks .
E4
E1
E9
E8
Water or something on the button.
Keep pressing a butt on more than 30 seconds.
Open circuit or break of distributary valve.
Failure of orientation of di stributary valve.
To Next Page
Loading...
