Witheachwashcycle.
Compartment
For programmes with pre-wash on ly.
(Follow the user instr uctions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Fill the detergent disp enser
Scrape off any large amount of leftover food. Soften remnants of burnt food in pans,
then l oad the baskets. Refer to the dishwasher loading instructions.
Switchontheappliance PresstheON/OFFbuttontoswitchontheappliance,Openthedoor.
Quick operation guide
For detailed operating method read the co rresponding conte nt on t he instruction man ual.
Select a programme
Close the door , t urn on the water tap and press the . The machine will start working
after about 10 seconds.
Start/Pause Button
Running the dishwasher
Switch off the applia nce
Turn off the water tap,
unload the baskets
Warning: wait a few minutes (about 15 minutes) before unloading the dishwasher to avoid handl i ng
the dishes and utensils while they are still hot and more susceptible to break .
They will also dry better.Unload the appliance, starting from the lower basket.
Changing the programme
Add forgotten dishes in the
dishwasher .
Press the Programme Button until the selected programme lights up .
( See the section entitled Operationg instruction )“”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the ON/OFF Button.
If the appliance is switched
off during a w ash cycle.
Open t he do or c ar efully.
Hot st eam may escape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
1. A running cycle can o nly be modified if it has been running for a short time. Otherwise the detergent
m ay have already been rele ased and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2.
P ress the Start/Pause button, the machine will be in standby state, pr ess the program
button more than 3 seconds then you can change the program to the desired cycle setting
1.Press the Start/P ause Button to stop the washing.
2.Open the door a little .
3.After the spra y arms stop workin g, you can open the door
completely.
4.Add forgotten dishes.
5.Close the door
6.Press the Sta rt/Pau se Button, the dishwasher will run
after 10 seconds.
To Next Page
Loading...
