Warning and safety notes
Never leave the charge unsupervised when it is
connected to its power supply.lf any malfunction
is observed immediately terminate the process
and refer to the operation manual.
Keep away the unit from dust,damp,rain,heat
direct sunshine and vibration.Do not drop it.
The circuit of the unit is designed to be powered
by 12V DC only.
This unit and the battery to charge should be set
up on a head-resistant,non-inflammable and non-
condu-ctive surface. Never place them on a car
seat,carpet or similar situation.
keep all the inflammable volatile materials well
away fom operating area.
Be sure to understand the information of the
battery to be charged accuraltely. lf the program
is set up incorrectly the battery to be charged.
Reverse the sequence when disconnecting.
To avoid short-circuits between the charge lead.
always connect the charge cable to the unit first.
Reverse the sequence when disconnecting.
Do not connect more than one battery pack to
the charge lead at any one time.
Do not attempt to charge or discharge the
following types of battery.
--Battery pack which consists of different types of
cell(including
different manufacturers)
--Battery is already fully charged or just slightly
discharged.
--Non-rechargeable batteries (Explosion hazard).
--Batteries that require a different charge
technique from Nicd,NIMH,Li-Poly or Pb.
--Faulty or damaged battery.
--Battery fitted with an integral charge circuit or a
protection circuit.
--Batteries installed in a device or which are
electrically linked to other components.
--Batteries that are not expressly stated by the
manufacturer to be suitable for the currents the
charger delivers during the charge process.
Please bear in mind of checking the following
point before charge operation.
--Did you select the appropriate program which
are suitable for the type of battery?
B5
li-ion/Polymer Balance Charger
To Next Page
Loading...
