05
SPECIAL FEATURES
Processing time limit:
You can also limit the maximum process time to avoid any possible defect.
Data store/load
The maximum five batteries' data can be stored for users' convenience. You can keep
the data pertaining to program setting of the battery of continuous charging or
discharging. Users can call out these data at any time without any special program
setting.
Cyclic charging/discharging
1 to 5 cyclic and continuous process of charge>discharge or discharge>charge is
operable for battery refreshing and balancing to stimulate the battery's activity.
04
Fast and storage mode of lithium battery
Purposes to charge Lithium battery varies, 'fast' charge reduce the duration of charging,
whereas 'store' state can control the final voltage of your battery, so as to store for a long
time and protect useful time of the battery.
Maximum safety
Delta-peak sensitivity: The automatic charge termination program based on the
principle of the Delta-peak voltage detection. When the battery's voltage exceeds the
threshold, the process will be terminated automatically.
Automatic charging current limit
You can set up the upper limit of the charging current when charging your NiCd or NiMH
battery; it is useful for the NiMH battery of low impedance and capacity in the 'AUTO'
charging mode.
Capacity limit
The charging capacity is always calculated as the charging current multiplied by time. If
the charging capacity exceeds the limit, the process will be terminated automatically
when you set the maximum value.
Temperature threshold*
The battery's internal chemical reaction will cause the temperature of the battery to rise.
If the temperature limit is reached, the process will be terminated.
* This function is available by connecting optional temperature probe, which is not
included in the package.
PC based analysis uing USB Communication
iMAX Quttro B6 offer PC based program can analysis the characteristic of the battery
via USB port. It shows a graph of voltage, current, capacity curves. It also shows the
individual voltage of each cell in the Lithium battery pack.
PC-LINK USB adaptor can be purchased separately
WARNING AND SAFETY NOTES
These warnings and safety notes are particularly important.Please follow the
instructions for maximum safety; otherwise the charger and the battery can be
damaged or at worst it can cause a fire.
Never leave the charger unattended when it is connected to its power supply. If
any malfunction is found, TERMINATE THE PROCESS AT ONCE and refer to the
operation manual.
Keep the charger well away from dust, damp, rain, heat, direct sunshine and
vibration. Never drop it.
The allowable input voltage is 11~15V DC
This charger and the battery should be put on a heat-resistant, noninflammable
and nonconductive surface. Never place them on a car seat, carpet or similar.
Keep all the inflammable volatile materials away from operating area.
Make sure you know the specifications of the battery to be charged or
discharged to ensure it meets the requirements of this charger. If the program is
set up incorrectly, the battery and charger may be damaged .It can cause fire or
explosion due to overcharging. This warranty is not valid for any damage or
subsequent damage arising as a result of a misuse or failure to observe the
procedures outlined in this manual.
To Next Page
Loading...
