imenco Goblin Shark - Contact

Goblin Shark - User Manual
3
IMENCO AS Visiting Address: Kophaug 3, 5570 Aksdal, Norway Office: +47 52 86 41 00 imenco@imenco.com
Org No: 923 005 749 MVA Postal Address: PO. Box 2143, 5504 Haugesund, Norway Fax: +47 52 86 41 01 www.imenco.com
4.1 Hazards and protective measures ...................................................................... 11
4.2 Over-temperature precautions ............................................................................ 11
5 Displaying the video stream ........................................................................................ 12
5.1 Imenco SubVIS SmartView ............................................................................................ 12
5.2 Media players .................................................................................................................. 12
5.3 Camera module settings ....................................................................................... 12
6 Maintenance .................................................................................................................... 13
6.1 General maintenance ............................................................................................. 13
6.2 Service and Repair .................................................................................................. 13
7 Packing & Shipping ........................................................................................................ 13
Contact
for assistance / clarification on any of the contents of this manual, please contact:
Imenco AS Subsea Electronics
Kophaug 3
5570 Aksdal NORWAY
Tel: +47 52 86 41 00
E-mail: imenco@imenco.com
www.imenco.com
Safety information
IMPORTANT! The Imenco Goblin Shark camera is a technically advanced
product. Please make sure to read and understand all sections of this manual
before installing or operating this product. Installation of this product should
only be performed by qualified personnel.
WARNING! This product contains no user serviceable parts. Do not open, alter or
disassemble this product.
Failure to comply with this warning can result in damage to equipment and void
of warranty. The camera is filled with inert gas at manufacture.
WARNING! The housing is NOT connected to any Protective Earth circuits.
The metal housing has no electrical contact with any of the circuits inside the