4. HOW TO USE THIS DEVICE?
1.Please check the skin and hair color chart (Page 4 Picture 3) and check
who can use this device (Page 4) to see whether the intended skin area can
be treated with this device. If your skin color is at a critical value, please use it
under professional guidance or contact us.
2.Shave and clean the treatment area. After your skin is cleaned, then follow
the next step. If your skin is experiencing sensitivity (redness), you cannot
use this device. Don't wax or pluck hair.(If you wax on treatment skin, please
wait for at least 72 hours.)
3.Plug in and connect the host with power and wear glasses (This device
must be connected with power during use). Long press the power button
(Page 2 picture 1) for 3 seconds to start it.
4.Conduct skin sensitivity test and choose proper energy level on your
treatment area.
4.1 Before The Treatment
07
08
4.1.If you are using the system for the first time or on a new area, choose a
small area close to the intended area to perform a skin sensitivity test. Start
at level 1{short press the power button to adjust the level} Follow the
treatment instructions below but make sure to emit only 2-3 pulses. After the
skin test, wait 60 minutes and check your skin for any reaction. If the skin
appears normal and there is no redness or other skin reaction in 60 minutes,
then you are ready to perform a full treatment.
4.2.Choose suitable energy level according to your skin tolerance and
increase energy level from one to five gradually. If there is no abnormal
reaction, you could increase energy level gradually. Don't hold the laser
window still over one spot and flash multiple pulses on the skin. It may cause
too much heat and may result in skin swelling, blisters, or temporary or
permanent changes in the color of your skin. After each flash, move
treatment window slowly to adjacent skin area.
4.3.Press the operation button for 3s can start automatic flash function. Once
automatic flash function start, the level icon will flash. If you want to use
manual flash function, just need to press the operation button.
Before returning to a previously treated skin spot, wait for at least 3 minutes.
Each time you press the treatment level button, the level will increase. Once
the device is at maximum level, you can press the treatment level button
again to downgrade levels.
To Next Page
Loading...