Imer Group H110VF - User Manual

Need help?

Do you have a question about the Imer Group H110VF and is the answer not in the manual?

Summary

Details the electrical panel, mains connection, and wiring procedures.

Explains how to start the machine and check the disc rotation direction.

Describes the function and operation of the emergency stop button.

Explains the thermal cut-out safety device and its reset procedure.

Extends the work table length from 900 mm to 1640 mm using an additional table.

Describes the polycarbonate guard protecting the blade and its maintenance checks.

Explains how to adjust the cutting height from 0 to 110 mm using a lever.

Details the use of the workpiece guide square for longitudinal and inclined cuts.

Explains how to use the workpiece guide square for cutting wedge shapes.

Describes the steel lower guard, its functions, and removal for maintenance.

Guides on how to replace the cutting disc, including safety precautions.

Details the process for adjusting and replacing the machine's drive belts.

Explains the use of the pusher rod and block for guiding small workpieces safely.

Outlines daily checks, protection assembly, wedge alignment, and blade distance.

Details periodic checks, cutting disc stopping time, and drive belt condition.

Provides guidance on moving the machine, including using lifting equipment or kits.

Describes an accessory kit for easier manual movement of the assembled machine.

Instructions for proper disposal of the machine at the end of its service life.

General