IMER SYNTESI 140 EL User Manual (English)

Other manuals for IMER SYNTESI 140 EL

Questions and Answers:

J
Jessica GregoryAug 4, 2025
What to do if the IMER Construction Equipment motor does not start?
- W
  William LynchAug 4, 2025
  If the IMER Construction Equipment motor doesn't start when you turn the switch, several things could be the issue. First, check the power cables and ensure the plug is correctly inserted into the socket. Also, verify that the power cable from the plug to the control panel is securely connected. Inside the motor circuit board or the panel, a wire may have become loose or disconnected; remake those connections. If these steps don't work, the main switch might be faulty and need replacement, or the overload safety device may have been activated. In the latter case, wait a few minutes before restarting the machine.
R
Robert CookAug 8, 2025
Why does the IMER Construction Equipment mixer drum RPM decrease during mixing?
- D
  David SandersAug 8, 2025
  If the mixer drum RPM decreases during mixing with your IMER Construction Equipment, the belts may be worn or slack. You should tension or replace the belts to resolve this issue.
W
William OlsonAug 13, 2025
What to do if the handle of IMER Construction Equipment turns by itself when unloading?
- J
  James SchwartzAug 13, 2025
  If the handle of your IMER Construction Equipment turns by itself when unloading, the tipping brake is likely worn and needs to be replaced.
J
James BarberAug 19, 2025
What to do if the IMER Mixer motor does not start when the switch is turned?
- M
  martinezwilliamAug 19, 2025
  If the IMER Mixer motor fails to start when you turn the switch, several issues could be the cause. First, check the power cables and ensure the plug is correctly inserted into the socket. Also, inspect the power cable from the plug to the control panel and wires inside the motor circuit board and panel for any detachment, and remake the connection if needed. If these steps don't resolve the issue, the main switch might be faulty and require replacement. Finally, the overload safety device may have been activated; wait a few minutes before restarting the machine.