To Next Page
P
paulabryantAug 10, 2025
What to do if the motor does not run when the switch is pressed on my IMER Construction Equipment?
- JJermaine ColeAug 10, 2025
If the motor of your IMER Construction Equipment does not run when the switch is pressed, it could be due to several reasons: - There might be no power in the supply line, so check the line. - The electric plug and socket may not be properly connected; ensure a proper connection. - The cable from the plug to the electric panel could be broken; in this case, replace the cable. - A wire might have become disconnected on the terminal board; remake the connection. - The switch itself may be faulty; replace the switch. - A fuse might have tripped; change the fuse in the electric panel. - The thermal protection device may have been tripped; wait a few minutes and try again.
General
