Imetec P8403 - Page 23

19
EN
MAINTENANCE
REPLACING THE OLD ANTI-SCALE FILTER
NOTE: The anti-scale filter (14) used may contain drops of water.
Place a cloth under the anti-scale filter to prevent these drops falling on to the floor.
ZEROCALC ANTI-LIMESCALE SYSTEM
Replace the anti-scale filter (14) when the red filter change indicator light (8A) begins flashing and the
iron emits a warning buzz.
To replace the old anti-scale filter, proceed as follows:
Open the filter flap (2).
Remove the anti-scale filter (14) from its casing.
Remove the protective red rubber pads from the anti-scale filter (14).
Insert the anti-scale filter (14) in the housing and pressing firmly into position [Fig. B].
Closes the filter flap (2).
Keep button 8B pressed for at least 1 second.
The iron will make a sound, and the indicator light (8A) will switch off.
The iron is now ready to be used.
NOTE: When using the iron for the first time or whenever the filter is replaced, on pressing
the steam request button (13), a slight buzz will be heard and the iron will not generate
steam.
This is absolutely normal and is caused by the anti-scale filter filling up. Keep the steam
request button (13) pressed for at least 1 minute, until the buzzing stops and the iron begins
to deliver steam.
NOTE: the electronic system modifies steam emission to safeguard the lifespan of the
product. The anti-scale filter (14) must be replaced as soon as possible.
Failure to replace the anti-scale filter (14) will invalidate the warranty.
CLEANING
WARNING! Make sure the plug is disconnected from the
socket and the plate has cooled down completely before
cleaning the iron.