What to do if my Imetec Iron is dispensing little or no steam?
If your Imetec Iron is dispensing little to no steam, there could be a couple of reasons. First, check if the steam selector is in the steam closed position and move it to the desired position. Second, make sure there is enough water in the reservoir; if not, fill it.
Why does water leak from my Imetec FERRO A VAPORE Iron plate?
Water may leak from the plate of your Imetec Iron due to a couple of reasons. One reason might be that the plate temperature is too low because the super-steam button is being pressed too frequently; allow slightly longer intervals between steam bursts. Another reason could be that the temperature adjustment knob is set too low; adjust it to a position between the 3 dots and the maximum temperature.
Why does my Imetec Iron plate remain cold or not heat up?
If the plate of your Imetec Iron remains cold or does not heat up, it could be due to a couple of reasons. First, check if the power supply cable is correctly inserted into the socket or try another socket. Second, ensure that the temperature adjustment knob is not set to the minimum temperature.
Why do impurities from my Imetec FERRO A VAPORE stain my garments?
If impurities from your Imetec Iron are staining your garments, here's what might be happening and how to address it: - Possible residues in the plate: Perform self-cleaning. - Chemical additives, scented liquids, or descaling agents are being used: Do not add additives to the water in the reservoir, as these substances can damage the product. - Starch is being used: Always spray starch on the reverse side of the fabric.
Why does the Imetec Iron plate temperature LED go on and off?
The switching ON and OFF of the LED indicates the heating phase of the Imetec Iron. The LED goes off once the set temperature is reached.
Optimises steam production for reduced energy consumption.
Instructions for dry ironing with the steam selector in the closed position.
Guidance on adjusting steam output and steam dispensing positions.
How to use the super-steam function for intense steam shots and vertical steaming.
Using the spray button for dense spray or mist on fabrics.
Description of the permanent resin filter that reduces water hardness.
Procedure for cleaning the iron's plate from limescale and impurities.
Instructions for cleaning the appliance plate and plastic parts.
To Next Page
General