What to do if my Imetec INTELLIVAPOR K5 Iron is not dispensing steam?
If only a little steam or no steam is dispensed, check that the steam selector is set to the desired field (Fig. B). Also, make sure there is enough water in the reservoir and fill it if necessary.
What to do if impurities from my Imetec INTELLIVAPOR K5 Iron stain clothes?
If impurities from the steam holes are staining your garments, this could be due to residue in the steam chamber or plate. Perform the Self Clean procedure. It could also be caused by using chemical additives, scented liquids, or descaling agents. Do not add these substances to the water reservoir, as they can damage the product. If you are using starch, make sure to always spray it on the reverse side of the fabric.
Why is my Imetec INTELLIVAPOR K5 Iron leaking water from the plate?
If water leaks from the plate, it may be because the plate temperature is too low due to the super-steam button being pressed too often. Allow slightly longer intervals between steam jets.
Why is my Imetec INTELLIVAPOR K5 plate not heating up?
If the plate remains cold or does not heat up, there may be no power supply. Verify that the plug is correctly inserted or try another socket. Also, ensure the O/I switch is in the "I" position.
Why does the temperature LED on my Imetec INTELLIVAPOR K5 keep going on and off?
The switching on and off of the LED indicates the heating stage of the iron, which is normal.
General| Power | 2400 W |
|---|---|
| Water Tank Capacity | 350 ml |
| Soleplate Material | Ceramic |
| Vertical Steam | Yes |
| Anti-Drip System | Yes |
| Type | Steam Iron |
| Steam Pressure | 5 bar |
| Anti-scale System | Yes |
| Auto Shut-Off | Yes |
| Steam Output | 50g/min |
To Next Page