What to do if my Imetec INTELLIVAPOR K3 isn't dispensing steam?
If your Imetec Iron is not dispensing enough steam, or no steam at all, first ensure that the steam selector (4) is set to the desired level (Fig. B). If the steam selector is correctly set, check the water reservoir (10) and fill it if it's low.
Why is my Imetec Iron plate not heating up?
If the plate (9) of your Imetec Iron remains cold or does not heat up, verify that the plug (13) is correctly inserted into the socket. Try another socket to rule out power issues. Also, make sure that the O/I switch (11) is in the "I" position.
Why does the plate temperature LED on my Imetec INTELLIVAPOR K3 go on and off?
The plate temperature LED (1) of your Imetec Iron goes on and off because it is a normal procedure. The switching on and off of the LED indicates the heating stage of the iron.
To Next Page
General