16
EN
CLEANING
WARNING! Make sure the plug of the appliance is
disconnected from the socket and the plate has
cooled down completely before cleaning the iron.
Any starch deposits or residue on the surface of the plate can be removed with a damp cloth
and non-abrasive liquid detergent.
Avoid scratching the plate with steel wool or metal objects.
The plastic parts can be cleaned with a damp cloth and then wiped with a dry cloth.
TROUBLESHOOTING
This chapter describes the most common problems that can arise using the appliance. If
the problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem Possible cause Solution
The plate (9)
remains cold or
does not heat up.
There is no power supply.
Verify whether the plug (13) is
inserted correctly or try inserting it in
another socket.
Ensure the O/I switch (11) is in
position "I".
The plate
temperature LED
(1) goes on and
o.
Normal procedure.
The switching on and o of the LED
indicates the heating stage of the iron.
Only a little steam
or none at all is
dispensed.
The steam selector (4) is
set to 0.
Set the steam selector (4) to the
desired eld (Fig. B).
There is not enough water
in the reservoir (10).
Fill the reservoir (10).
To Next Page
Loading...
Need help?
General