Why is my Imetec TITANOX K113 Iron not steaming?
If your Imetec Iron isn't dispensing enough steam, or any at all, there are a couple of things to check: * First, ensure that the steam selector isn't set to '0'. Adjust it to your desired steam level. * Second, make sure that there's enough water in the reservoir. If it's low, refill it.
How to fix Imetec TITANOX K113 that is not heating up?
If the plate of your Imetec Iron isn't heating up, here's what to check: * First, ensure the iron is properly plugged into a working socket. Try another socket to be sure. * Second, make sure the temperature adjustment knob isn't set to the minimum temperature. Adjust it accordingly.
What to do if Imetec Iron is leaking water?
If water is leaking from the plate of your Imetec Iron, it could be due to these reasons: * The plate temperature might be too low because the Super-steam button is being pressed too often. Try allowing slightly longer intervals between steam bursts. * The temperature adjustment knob may be set too low. Turn it to the Max level.
Why does my Imetec Iron stain clothes?
If your Imetec Iron is staining garments, consider the following: * Avoid using chemical additives, scented liquids, or descaling agents in the water reservoir, as these can damage the product. * If you're using pure distilled or softened water, mix tap water (50%) with distilled or demineralized water (50%). * When using starch, always spray it on the reverse side of the fabric.
Why does the Imetec TITANOX K113 temperature light keep flashing?
The plate temperature LED (1) of your Imetec Iron going on and off is normal. It indicates the heating phase of the iron. The LED (1) goes off once the set temperature is reached.
Process for refilling the water reservoir, ensuring proper operation.
Guidance on setting the iron's temperature based on fabric type.
Instructions for using the iron in dry mode without steam.
Steps for operating the iron using steam for effective ironing.
Using the super-steam function for creases and vertical steaming.
How to use the spray function for dampening fabric during ironing.
Information on how to obtain service and support for the appliance.
General| Auto Shut-off | Yes |
|---|---|
| Anti-drip System | Yes |
| Self-cleaning Function | Yes |
| Voltage | 220-240 V |
| Steam Boost | 150 g/min |
To Next Page