EN
12
ACCESSORIES
Combination carpet/floor brush (6)
Adjust the combination brush according to the type of flooring, using the toggle switch (5A)
[Fig. C1]:
• toggle switch (5A) position A
(extended bristles): for hard floors [Fig. C1-A]
• toggle switch (5A) position B
(retracted bristles): for rugs and carpets
[Fig. C1-B]
USE
Fully unwind the power cable (4). To this end, turn the upper cable hook (2A) downwards
[FIG. D1].
Using the vacuum cleaner with the cable fully or partly wound involves an
overheating hazard!
NOTE:
1. Bear in mind that a new appliance can develop odours the first few times it is
used. These odours are harmless and disappear shortly afterwards. Ventilate
the room.
2. With use, transparent parts can become opaque.
Insert the plug into the socket, holding the appliance by the handle to prevent it from falling
in the event that it was not stored in OFF position.
Press the ON/OFF button (10) once to turn the vacuum cleaner on or off
[Fig. E1]:
Switch the appliance off after use, by pressing the ON-OFF button (10)
and disconnect
the plug from the socket.
Wind the power cable (4) around the two hooks (2A and 2B) [FIG. D1] and fasten the plug
to the cable using the rubber clamp on the plug.
To Next Page
Loading...
