Why is the motor temperature of my iMettos B10 too high, and the speed is low?
If the motor temperature of your iMettos Mixer rises excessively and the speed is lower than expected, there could be several reasons. First, check the supply voltage, as a lack of voltage may be the cause. Second, reduce the load to prevent overload. Finally, ensure that you have selected a suitable speed and agitator for the task.
What to do if the raising handle on my iMettos B10 is too tight?
If the raising handle of your iMettos Mixer is too tight, it could be due to corroded guide ways. To resolve this, clean and oil the guide ways. Alternatively, the lead screw, bevel gear, and hand wheel shaft might be dry; in this case, oil them.
How to fix iMettos Mixer when the mixing shaft doesn't rotate after switching on?
If the mixing shaft of your iMettos Mixer does not rotate after switching it on, the electric connectors might be loose. Inspect the electric circuit and tighten any loose connectors.
Why is my iMettos B10 Mixer leaking oil?
If you notice oil leaking from your iMettos Mixer, it's likely that the oil seals are worn out. You will need to replace these oil seals to stop the leakage.
General| Voltage | 220-240V |
|---|---|
| Frequency | 50Hz |
| Speeds | 3 |
| Material | Stainless steel |
| Power | 450 W |
| Bowl Capacity | 10 L |
To Next Page