6
Note: When installing blender, Stir-axis gear must be good size with the Stirrer Crossing in place to prevent falling.
5.Bowl lift:
a) When mixing, rotate the hand wheel to raise the bowl until it reaches the stop position, so that the food can be mixed
thoroughly.
b) Exchanging agitators and after mixing, rotate the hand wheel to lower the bowl so that the bowl and agitators can be
removed.
Note: When assembling an agitator, slip the agitator up on the shaft and turn it until the driving pin in the shaft reaches
the L-shaped slot in the agitator shank in order to avoid the agitator to fall down in running.
6.2. MAINTENANCE
1. After use each time, clean carefully the bowl, agitators etc., and make sure to keep the machine clean.
2. Lubricate the bowl slide ways regularly.
3. The transmission gearbox is packed with special grease that will be sufficient for six months. To add or replace grease, it
is necessary only to remove the upper cover and the bearing cover
6.3 USING THE MIXER FOR THE FIRST TIME
Refer to figure 1 for mixer component identification.
Before using for the first time, thoroughly clean the bowl and agitator, as described in section 7 of this manual.
Ensure that the mixer is firstly switched off (1)
Ensure the cover (11) is fitted to the hub (where applicable) if an attachment is not in use.
Always remove any attachments before using the agitator.
Lower the bowl support by rotating the bowl handle downwards (3)
Rotate the front guard cage assembly (10) to the open position
Place the required agitator (9) into the bowl (7) and lift bowl onto the bowl support (5)
Ensure that the rear bowl location (4) and side bowl pins (6) are correctly engaged
Slide the agitator onto the shaft, turning clockwise to engage the drive pin in the “L” slot of the agitator shank.
Add the ingredients into the bowl and raise the bowl using the handle (3)
Rotate the front guard cage (10) into the operating position.
Select the desired speed (12).
Start the machine by pressing the 'green' start button (1)
When mixing is complete stop the machine using the 'red' stop button (1)
Lower the bowl support, open the guard cage and remove the agitator from the shaft
Remove the bowl and agitator from the mixer for emptying and cleaning.
Speed setting 1 (LOW) is for heavy mixtures such as dough, heavy batters and mashed potatoes.
Speed setting 2 (MEDIUM-LOW) is for mixing cake batters, mashing potatoes and for developing dough.
Speed number 3 (MEDIUM-HIGH) is for mixing maximum 3 amount of air into light batches. The wire whip is used for
whipping cream, beating egg whites, mixing light icings, meringues and whipping.
To Next Page
Loading...