To Next PageTo Next Page
Need help?Do you have a question about the IMG STAGE LINE STA-500 and is the answer not in the manual?
General| Output Power at 4 Ohm | 500 W |
|---|---|
| Power Rating at 4 ohms | 500 W |
| Frequency Response | 20 Hz - 20 kHz |
| THD (Total Harmonic Distortion) | < 0.1% |
| THD | < 0.1% |
| Signal-to-Noise Ratio | > 100 dB |
| S/N ratio | > 100 dB |
| Signal to Noise Ratio | > 100 dB |
| Input Sensitivity | 0.775 V |
| Dimensions | 483 x 88 x 295 mm |
| Weight | 8.5 kg |
| Frequency range | 20 Hz - 20 kHz |
| Inputs | XLR |
| Outputs | Binding Posts |
| Input Impedance | 20 kΩ |
| Power Supply | 230 V AC |
| Cooling | Fan cooled |
Details about front panel controls and indicators like LEDs, volume controls, and power switch.
Details about rear panel connections, including speaker outputs, inputs, ground lift, and fuse holder.
Instructions for mounting the amplifier in a standard 19-inch rack, requiring 2U space.
Instructions for powering the amplifier on and off, including soft start protection.
How to set the input and output levels, including CLIP indicator usage.
Explanation of the ground lift switch for eliminating hum noise.
