IMI TA-SCOPE - Batteries and Charging; Charging TA-SCOPE Units Safely

10
Batteries
UpondeliverytheTA-SCOPEispartly
charged and prepared to start balancing
immediately. The Information bar on the
Handheld displays the battery status for
both Handheld and DpS-Visio whenever
communication is established.
The Handheld and Dp sensor(s) can be
charged at the same time through the multi-
charger.TheTA-SCOPEisdeliveredwithone
multi-charger and 2 charging cables.
Handheld is charged with a special charging
cable. DpS-Visio with the same cable as used
for communication with handheld (Hh) and
PC.
Charging – Operation instruction
(Choosethecorrectplug(gA).)
1. Connect the multi-charger to the wall
socket. Wait for the indicator to show green
colour.
2. Plug the device(s) into the USB port(s).
Capacity and charging
Warning! The supplied multi-
charger from IMI Hydronic
Engineeringmustbeused!
A
CAUTION! (Multi-charger)
1. Do not bend the blade or pins of the plug.
2. If there are any strange sound, smoke or odor, pull of the cable(s) immediately.
3.Donotdisassemble.(itmaycausereorelectricshock).
4.Donotputanysharpobjectsintotheventinghole.(itmaycausereorelectric
shock).
5.Ensuretoplugthemulti-chargerrmly.
6.Ensurenottousedamagedcable(s).(itmaycausereorelectricshock).
7.Ensurenottoplacethemulti-chargeronabed,bagorinsideaclosetthatis
not good for ventilation.
8.Alwayswipeo󰀨themulti-chargerwithasoftfabric,notwatermop.(watermay
cause electric shock).
9.Keepthepowerplugandoutletclean.(dirtmaycauseashortcircuitandre).
10. Keep the product out of reach of children.
!