Impecca Flex Series - Wired Controller Swing Function; Swing Mode Activation

3.6 Swing Setting
Swing On: Press Function under on state of the unit to activate the swing function. In this case,
Swing Off: When the Swing function is on, press Function to enter the Swing setting
interface,with
blinking. After that, press Enter/Cancel to cancel this function. Swing setting is
shown as Fig.3.6.1.
Fig.3.6.1 Swing Setting
Notes:
ķ .
Sleep, Turbo or Blow setting is the same as the Swing setting.
ĸ .
After the setting has been done, it has to press the key “Enter/Cancel” to back to the setting
Wired Controller
39