impro technologies HRW900-5-0-GB Series - User Manual

MODEL NUMBERs:
HRW903-5-0-GB-XX, HRW902-5-0-GB-XX
MDR901-5-0-GB-XX, MDK901-5-0-GB-XX
HRW900-5-0-GB-XX, HRW901-5-0-GB-XX
HRK900-0-5-GB-XX, HRK901-0-5-GB-XX
M
ULTI
-
DISCIPLINE
READERS
Impro Multi-discipline Readers
INSTALLATION MANUAL
SPECIFICATIONS
CSN Read Capability ...................
Slim Tags, Omega Tags, Impro Trinary Tags
(1074 and 2074), Philips HITAG™ 1, Philips
HITAG™ 2, HID Tags (H10301, H10302 and
H10304), ISO 15693-2 iClass Tags, ISO
18092 FeliCa Tags and ISO 14443A
MIFARE® Tags.
NOTE: HID, FeliCa and MIFARE® are
registered trademarks of HID
Global Corporation (an ASSA
ABLOY Group Brand), The Sony
Corporation and Koninklijke Phillips
Electronics N.V. respectively.
Working Environment
MDK901/HRW900
MDR901/HRW901
HRW903/HRW902.........................
Designed to work in an indoor or outdoor
environment similar to IP54. These models
are, therefore, sealed (conformal coated)
against water.
HRK900 & HRK901 .......................
Designed to work in an indoor environment
similar to IP20. These models are NOT sealed
against water and should not be exposed to
rain or splashes.
Installation
Please consult the instructions under
Installation Information, on page 4.
Blank Space

Summary

Product Specifications

CSN Read Capability and Supported Tags

Details CSN read capability, listing supported tag types like Slim Tags, Omega Tags, HID, FeliCa, MIFARE.

Environmental and Electrical Specifications

Covers working environment, IP ratings, input voltage, power, Wiegand bus, inputs, buzzer, and status indicators.

Installation and Mounting

Accessories and General Guidelines

Lists unpacking accessories, max data distance, cable specs, and noise reduction practices.

Mounting Procedures and Cautions

Provides instructions and cautions for mounting readers on vibration-free surfaces and in open environments.

Electrical Connections

Connections to Reader Modules & Controllers

Shows typical wiring for Wiegand Reader Module, Impro iTRT, and IXP20 Controller.

Advanced Controller & Interface Connections

Illustrates connections to IXP220, Impro MfT, Impro TA/iTA, and Impro RS/RH.

Configuration and Protocols

Tag Frequency and Output Modes

Explains how to configure Tag Frequency Modes and OEM Output Modes.

Wiegand Protocols and Keypad Settings

Details Wiegand 26/44-bit protocols, HID Normal, and keypad PIN code entry.

Advanced Configuration Modes

Describes setting Fixed Length Mode, Single Key 8-bit Burst Mode, and entering Facility Codes.

System Checks and Labels

Self-Test, Serial Labels, and Final Checks

Covers power-on self-test, serial number label attachment, and connection verification.

Warranty and Compliance

Guarantee Information and CE Status

States product conformance to warranty details and lists CE status for specific models.

impro technologies HRW900-5-0-GB Series Specifications