impro technologies HRK901-0-5-GB Series - User Manual

MODEL NUMBERs:
HRW903-5-0-GB-XX, HRW902-5-0-GB-XX
MDR901-5-0-GB-XX, MDK901-5-0-GB-XX
HRW900-5-0-GB-XX, HRW901-5-0-GB-XX
HRK900-0-5-GB-XX, HRK901-0-5-GB-XX
M
ULTI
-
DISCIPLINE
READERS
Impro Multi-discipline Readers
INSTALLATION MANUAL
SPECIFICATIONS
CSN Read Capability ...................
Slim Tags, Omega Tags, Impro Trinary Tags
(1074 and 2074), Philips HITAG™ 1, Philips
HITAG™ 2, HID Tags (H10301, H10302 and
H10304), ISO 15693-2 iClass Tags, ISO
18092 FeliCa Tags and ISO 14443A
MIFARE® Tags.
NOTE: HID, FeliCa and MIFARE® are
registered trademarks of HID
Global Corporation (an ASSA
ABLOY Group Brand), The Sony
Corporation and Koninklijke Phillips
Electronics N.V. respectively.
Working Environment
MDK901/HRW900
MDR901/HRW901
HRW903/HRW902.........................
Designed to work in an indoor or outdoor
environment similar to IP54. These models
are, therefore, sealed (conformal coated)
against water.
HRK900 & HRK901 .......................
Designed to work in an indoor environment
similar to IP20. These models are NOT sealed
against water and should not be exposed to
rain or splashes.
Installation
Please consult the instructions under
Installation Information, on page 4.
Blank Space

Summary

Product Specifications

CSN Read Capability

Lists compatible tag types including Slim Tags, Omega Tags, HITAG, HID, iClass, FeliCa, and MIFARE.

Working Environment and Protection

Electrical Connections

Wiegand Reader Module Connection

Shows typical connection of the reader to a Wiegand Reader Module via a printed circuit board.

Impro iTRT Interface Connection

Illustrates the connection of a Multi-discipline Reader to the Impro iTRT Printed Circuit Board.

IXP20 Controller Connection

Details the connection of a Multi-discipline Reader to the IXP20 Controller Printed Circuit Board.

IXP220 Controller Connection

Demonstrates connecting the Multi-discipline Reader to the IXP220 Controller Printed Circuit Board.

Impro MfT Connection

Shows the connection of a Multi-discipline Reader to the Impro MfT Printed Circuit Board for third-party equipment.

Impro TA;iTA Connection

Impro RS;RH Connection

Tag Configuration and Data Protocols

Configuring Tag Frequency Mode

Explains how to select one of three Tag Frequency Modes (125 kHz, 13.56 MHz, or both).

Setting Output Mode (OEM)

Wiegand 44-bit Protocol

Wiegand 26-bit Protocol

impro technologies HRK901-0-5-GB Series Specifications