To Next PageTo Next Page
Need help?Do you have a question about the impro technologies HRW903-5-0-GB Series and is the answer not in the manual?
General| Model | HRW903-5-0-GB Series |
|---|---|
| Category | Card Reader |
| Manufacturer | Impro Technologies |
| Ingress Protection | IP65 |
| IP Rating | IP65 |
| Housing Material | ABS Plastic |
| Buzzer | Yes |
| Dimensions | 103mm x 48mm x 22mm (4.06" x 1.89" x 0.87") |
| Output Format | Wiegand |
| Communication Interface | RS485 |
| Current Consumption | Max 100mA |
| Supported Card Types | MIFARE Classic, DESFire EV1 |
| LED Indicators | Red, Green, Amber |
Lists supported tag types including Slim, Omega, HITAG, HID, iClass, FeliCa, MIFARE.
Details environmental conditions (IP54/IP20) for different reader models.
Specifies acceptable input voltage range and polarity sensitivity.
Covers Wiegand bus interface, data format, and input characteristics.
Details PIN code entry, ranges, and durability for specific models.
Describes the tri-colored status LED (Red, Green, Amber).
Explains optical and mechanical anti-tamper outputs.
Lists items included with the Multi-discipline Reader upon unpacking.
Specifies maximum cable length and conductor gauge for reliable communication.
Advises on spacing readers and mounting surfaces for optimal performance.
Illustrates typical wiring for connecting to a Wiegand Reader Module.
Illustrates typical wiring for connecting to the Impro iTRT.
Illustrates typical wiring for connecting to the IXP20 Controller.
Illustrates typical wiring for connecting to the IXP220 Controller.
Illustrates typical wiring for connecting to the Impro MfT.
Illustrates typical wiring for connecting to Impro TA or Impro iTA.
Illustrates typical wiring for connecting to Impro RS or RH.
Explains how to select between 125 kHz, 13.56 MHz, or dual-frequency modes.
Details how to select between different output modes (HID Normal/Raw, 26/44-bit).
Describes the structure of Wiegand 44-bit data transmission.
Describes the structure of Wiegand 26-bit data transmission.
Details PIN entry, correction, and fixed length key output for keypad models.
Describes how to set key buffer length and parity for Fixed Length Mode.
Explains how to select 8-bit code reporting per key press.
Explains how to enter a Facility Code for PIN-based readers.
Describes the self-test procedure and expected beeps/LED indications.
Lists models with CE status.
Directs users to the website for warranty details.
