6 |
3.3 Scanner Updates
The app automatically checks the IMV licence server for scanner software updates when
connected to Wi-Fi.
After connecting to an EASISCAN, you may be prompted to update the scanner software. The
scanner will only update if the battery is above 50% charge.
Press OK or Cancel. Pressing OK will cause the scanner LEDs to ash yellow - the scanner will take
roughly two minutes to update. Press cancel if you wish to update later.
Once the update is nished the scanner will switch off. The scanner software version number can
be checked in the User Settings section.
4. IMV Go Scan App
4.1 Live scanning
*Change the channel in Wi-Fi settings. No indicator: clear channel on the 5GHz band. This is the
recommended state. White indicator: clear channel, but is on 2.4GHz band, it is more prone to
interference. Orange/red indicator: channel has other networks or scanners on it. This is likely to
cause interference issues.
Recording
indicator
and elapsed
time during
recording.
Wi-Fi channel quality*
No probe
contact,
scanner enters
low-power
mode and the
screen will dim.
The scanner
battery
level
The smart
device
battery level
To Next Page
Loading...