— 3 —
A. Assembly Instructions
1) After opening the box,
cut the plastic ties
that secured the
U-Step II in transit.
2)
Lift up on the tube
at
the top near the seat so
that the seat becomes
horizontal with the
ground.
Press the seat down
until it snaps into place.
(Below)
3)
Install the left and the right
handlebars.
If you have any doubt which is the
left and right handlebar, look at the
junction box below the seat and
you can see the left handle bar
cable is connected into the left side
and vice versa for the right.
Junction Box
Right Handlebar
Left Handlebar
To Next Page
Loading...