In-Step Mobility U-Step II - Braking; Releasing the Brakes; Tension Control Adjustment; Adjusting Tension Control

— 6 —
B. Braking
The U-Step II wheels will not
roll until you release the brakes
in one of the following ways:
1) Squeeze either or both hand
brake levers to release the
brakes.
2) Pull up on the release bar of
the alternative brake accessory
discussed in section H.
1) Not everyone needs to adjust the tension control to be safe.
However, if you feel that the U-Step II rolls too easily for you,
use the tension control to add resistance. Place your U-Step II
on the surface where you walk most often. You will need more
tension on a smooth surface such as flooring than you will on
carpet.
2) Using a flat head screwdriver, loosen the locking blot about
two turns.
C. Tension Control Adjustment (Optional)
Tension Control Lever - Notched
Set
Holes
Tension
Locking
Bolt
Tension
Lever
T
e
n
s
i
o
n
I
n
d
i
c
a
t
o
r
(
s
t
i
c
k
e
r
)