https://wiki.teltonika-gps.com/view/Inateck_BCST-70_Configuration
Inateck BCST-70 Configuration
Main Page > Accessories > Inateck BCST-70 Barcode Scanner > Inateck BCST-70 Configuration
Contents
1 Configure FM device using Teltonika configurator
2 Enable Bluetooth Pairing
3 Scanner Auto Connect Configuration
Configure FM device using Teltonika configurator
In System settings, enable Codec8 Extended1.
In GPRS settings, configure GPRS Settings and Server Settings.2.
In Bluetooth settings,3.
Enable Bluetooth, set this setting as either "Enable (hidden)" or "Enable (visible)",
otherwise Bluetooth will be disabled
Under Bluetooth Control, click Discover so it would detect devices within vicinity.
Once devices are discovered, select BCST-70-XXXX-SPP then proceed to tick Pair
After successful pairing, scanner should show under Paired Devices.
NOTE: : If in case the Scanner is not discovered, do the following steps on Bluetooth Pairing.
Enable Bluetooth Pairing
Scan “Enter Setup”a.
To Next Page
