Need help?Do you have a question about the Incon TS-550 and is the answer not in the manual?
General| Brand | Incon |
|---|---|
| Model | TS-550 |
| Category | Measuring Instruments |
| Language | English |
Covers important notices, trademarks, warranty information, and contact details for FFS.
Explains safety symbols and critical precautions for installation and operation in hazardous environments.
Provides a general overview of the TS-SCM system and illustrates a typical installation.
Details required containment volumes, vacuum levels, and available system configurations.
Emphasizes safety procedures like lockout/tagout and site surveys before installation.
Covers wiring requirements, conduit, mounting the SCCM, and installing the siphon check valve.
Details on plumbing vacuum hoses and securing containment connections.
Instructions for wiring the solenoid to the console's relay module.
Steps for wiring the vacuum sensor to the 4-20mA Analog Input Module.
How to configure the AC Input Module for dispenser hook signals.
Configuration details for 4-20mA Input and Relay modules.
An example illustrating the setup of the Relay Module for SCM.
Configuration and example for using TPI to control STPs.
Details on setting up the SCM application and its parameters.
Describes the SCM Status Summary screen and its indicators.
Explains indicators and controls on the SCM Control screen.
Covers safety warnings, required equipment, and the containment tightness test procedure.
Instructions for vacuum gauge setup and identifying leaks during testing.
Detailed steps for conducting the STP Siphon Flow Rate Test and associated warnings.
Guidelines on when to re-learn and the step-by-step learning process.
Explains messages displayed during the SCM learning process and their meanings.
Instructions on how to generate and view SCM alarm and event reports.
Guide to identifying and troubleshooting SCM alarms and warnings using error codes.
Step-by-step instructions to clear active SCM alarms from the console.
How to enable/disable SCM channels for monitoring containment status.
Steps to conduct the annual functional test for SCM leak detection verification.
To Next Page
