To Next Page
B
Brian McguireSep 9, 2025
Why Indesit DFG 15B10 leaves streaks on dishes?
- AAshley FarmerSep 9, 2025
Streaks or a bluish tinge on dishes and glasses from your Indesit dishwasher are often caused by a rinse aid dosage that is too high.
Why Indesit DFG 15B10 leaves streaks on dishes?
Streaks or a bluish tinge on dishes and glasses from your Indesit dishwasher are often caused by a rinse aid dosage that is too high.
Why Indesit DFG 15B10 Dishwasher leaves white film on dishes?
A white film or limescale deposits on dishes and glasses from your Indesit dishwasher can be due to several reasons. Check if the dishwasher needs refined salt. The water hardness adjustment might not be suitable, so increase the relevant values. Ensure the salt and rinse-aid dispenser cap is properly closed, and that the rinse aid hasn't been used up or the dosage is too low.
Why Indesit Dishwasher dishes are not clean?
If your dishes aren't coming out clean, several factors could be at play. Ensure the crockery is arranged properly so the spray arms can rotate freely. A wash cycle may be too gentle. Also, too much foam from incorrectly measured or unsuitable detergent can cause this issue. Check that the lid on the rinse aid compartment is closed correctly, and that the refined salt level is adequate. Dirty or clogged filters, or clogged holes in the spray arms, can also prevent proper cleaning. Lastly, confirm the height of the dishes is compatible with the rack adjustment.
Why is my Indesit Dishwasher not drying properly?
If your crockery isn't drying properly in your Indesit dishwasher, it could be because a wash cycle without a drying program was selected. Also, the rinse aid might be used up, or the rinse aid dispenser setting might not be suitable. Note that crockery made from non-stick material or plastic may naturally retain water drops.
How to fix an Indesit DFG 15B10 Dishwasher that does not start?
If your Indesit dishwasher doesn't start or cannot be controlled, make sure the water supply tap is turned on. Try switching the appliance off and on using the ON/OFF button, waiting about a minute before switching it back on and resetting the wash cycle. Ensure the appliance is properly plugged in or try another electricity socket. Also, verify that the dishwasher door is fully closed.
Why are the dishes not clean after using my Indesit DFG 15B10 Dishwasher?
If your Indesit dishwasher isn't cleaning dishes properly, ensure the crockery is arranged correctly and that the spray arms can rotate freely. A wash cycle might be too gentle for the load. Also, check if too much foam is present, indicating incorrect detergent usage. Ensure the rinse aid compartment lid is correctly closed and that the filter isn't dirty or clogged. Verify the refined salt level and ensure the height of the dishes is compatible with the rack adjustment. Lastly, inspect the sprayer arm holes for clogs.
What to do if no water drain out of the Indesit DFG 15B10?
If your Indesit dishwasher isn't draining water, it might be due to several reasons. The wash cycle may not have finished yet, so allow it to complete. The water drain hose could be bent, so check its installation. The drain duct might be clogged, so inspect and clear it. The filter could also be clogged with food residues, so clean it. Finally, check the height of the drain hose.
How to fix an Indesit DFG 15B10 that does not start or cannot be controlled?
If your Indesit dishwasher won't start or cannot be controlled, make sure the water supply tap is turned on. Try switching the appliance off and on again after about a minute, then reset the wash cycle. Ensure the appliance is properly plugged in and try another socket if necessary. Also, confirm that the dishwasher door is closed properly.
Why are the dishes not clean in my Indesit DFG 15B10 Dishwasher?
If your Indesit dishwasher isn't cleaning dishes properly, ensure the crockery is arranged correctly and that the spray arms can rotate freely without being hindered by the dishes. Check that you've selected an appropriate wash cycle. Too much foam can also cause this problem, so make sure you're using the correct amount and type of detergent. Also, verify that the lid on the rinse aid compartment is properly closed. A dirty or clogged filter can also cause cleaning issues, as can a low refined salt level. Finally, ensure the height of the dishes is compatible with the rack adjustment and that the holes in the spray arms are not clogged.
What to do if my Indesit DFG 15B10 Dishwasher won’t load any water and is blocked with flashing lights?
If your Indesit dishwasher won't load water and shows flashing lights, it could be due to several reasons. First, ensure that there is water in the mains supply and that the tap is fully open. Next, check the water inlet hose for any bends that might be restricting the water flow. Also, inspect the filters to see if they are clogged and need cleaning. Additionally, a clogged drain duct can also cause this issue, so make sure to clean it. After checking and cleaning these components, try switching the dishwasher off and on, then start a new wash cycle. If the issue continues, turn off the water tap, unplug the appliance, and seek assistance from a qualified service center.
General safety rules for operating the appliance.
Guide to positioning and levelling the dishwasher correctly.
Instructions for connecting water and electricity supplies.
Steps and precautions for making the electrical connection.
Guidance for the initial wash cycle after installation.
Information and steps for seeking technical assistance.
Step-by-step guide to starting a wash cycle.
Instructions on how to correctly measure and add detergent.
Procedures for safely shutting off water and electricity.
General| Type | Freestanding |
|---|---|
| Appliance placement | Freestanding |
| Control panel colour | White |
| Noise Level | 51 dB |
| Delayed start timer | Yes |
| Water consumption per cycle | 11 L |
| Energy Efficiency Class | A |
| Annual Energy Consumption | 295 kWh |
| Annual Water Consumption | 3080 L |
| Width | 600 mm |
| Depth | 600 mm |
| Height | 850 mm |
| Drying Efficiency Class | A |
| Weight | 47 kg |
| Delay Start | Yes |
| Half Load Option | No |
| Number of Place Settings | 13 |
| Washing programs | Eco, Intensive, Normal, Rapid |
| Delay start (max) | 9 hours |
| Programs | Eco, Intensive, Normal, Rapid |
