To Next PageTo Next PageWhy Indesit DFP 584 Dishwasher doesn't start?
Your Indesit dishwasher might not start because the plug isn't properly inserted or there's no power. Ensure the dishwasher door is fully closed. Also, check if a delayed start has been programmed.
What to do if Indesit Dishwasher dishes are not clean?
If your Indesit dishwasher isn't cleaning dishes properly, check if the racks are overloaded or the crockery isn't arranged well. Make sure the sprayer arms can move freely. The selected wash cycle may be too gentle. An excessive amount of foam may have been produced because the detergent has not been measured out correctly or it is not suitable for dishwashers. Ensure the lid on the rinse aid compartment is closed correctly, the filter isn't dirty or blocked, and the refined salt level is adequate.
What to do if Indesit DFP 584 does not take in water and shows Tap shut-off alarm?
If your Indesit dishwasher displays the 'Tap shut-off alarm' (A:6) and emits beeps, it could be due to no water in the mains supply or a bent water inlet hose. First, turn on the tap; the appliance should start in a few minutes. If beeps activated the appliance lock, switch off the machine using the ON/OFF button, turn on the tap, and switch the machine back on after 20 seconds. Then, reprogram and restart the wash cycle.
What to do if Indesit DFP 584 shows Water intake solenoid valve malfunction alarm?
If your Indesit dishwasher displays the A:2 alarm, switch it off using the ON/OFF button, then switch it back on after one minute. If the alarm persists, shut off the water tap to prevent flooding, remove the plug, and contact assistance.
How to fix Indesit DFP 584 when no water drains out?
If water isn't draining from your Indesit dishwasher, first ensure the cycle has finished. Check if the water outlet hose is bent or the drain duct is blocked. Also, inspect the filter for food residue clogs.
Why Indesit DFP 584 crockery is not dried properly?
If your Indesit dishwasher leaves crockery not dried properly, it might be because a wash cycle without a drying program was selected. Also, the rinse aid might be used up or the dosage is too low, or the rinse aid dispenser setting isn't high enough.
What to do if Indesit DFP 584 Dishwasher shows Water inlet hose alarm?
If your Indesit dishwasher displays the A:7 alarm, switch it off using the ON/OFF button. Shut off the water tap to prevent flooding and remove the plug. Ensure the water inlet filter hasn't become blocked by impurities.
Why Indesit Dishwasher is making excessive noise?
Excessive noise from your Indesit dishwasher could be because dishes are rattling against each other or the sprayer arms. Also, check if too much foam has been produced due to incorrect detergent dosage or unsuitable detergent.
Why Indesit DFP 584 Dishwasher dishes and glasses are covered in white film?
A white film or limescale on your Indesit dishwasher's dishes and glasses may be due to low refined salt levels or an incorrect dosage setting for your water hardness. Ensure the salt dispenser lid is properly closed. The rinse aid might be depleted or its dosage is too low. Also, the crockery could be made from non-stick material.
Why Indesit Dishwasher dishes and glasses are streaked?
Streaked dishes and glasses from your Indesit dishwasher may be caused by a rinse aid dosage that is too high.
General| Type | Freestanding |
|---|---|
| Energy Efficiency Class | A+ |
| Noise Level | 51 dB |
| Number of Programmes | 6 |
| Width | 60 cm |
| Half Load Option | Yes |
| Wash Programs | Eco, Intensive, Normal |
| Water Consumption | 11 L |
| Delay Start | Yes |
