Indesit ICD661UK - Fault Codes & Diagnostics

16 of 28
Service Manual UK
Indesit Company
English
FAULT CODES & DIAGNOSTICS
If an error is detected during the cycle, the programme will be terminated and one of the following errors
will be displayed using a combination of the programme LEDs on the console panel.
The relevant LED(s) will flash in the event of a fault. The On/Off LED will also flash.
Fig. 1 identifies the programme progress LED to the corresponding LED shown in the fault code chart.
Codes Meanings Possible Causes
'Dry' LED 3 flashing
quickly
Fill time 'Time Out'
Inlet valve is faulty or water intake is restricted
or water pressure too low.
'Rinse' and 'Dry' LEDs
2 and 3 flashing
quickly
Time out heating or not
reached temperature
Malfunction of temperature sensor or heating
element.
'Main Wash' LED 1
flashing quickly
Float Switch operated due
to water in base
MAchine over filled or is leaking.
'Main' and 'Rinse'
LEDs 1 and 2 flashing
quickly
Failure of temperature
sensor
Open circuit temperature sensor or wiring.
'Main', 'Rinse' and 'Dry'
LEDs 1, 2 and 3
flashing quickly
Failure of temperature
sensor
Short circuit temperature sensor.
_
___ ______
_
_
______
_
____
modify
the
fon
123
LEDs 1, 2, 3 flashing quickly and buzzing indicates a
Fault Condition