www.sacoapartments.com
Delay set
If the Delay Timer function has been enabled once you have started the programme the LED corresponding to
the delay set will begin to flash:
As time passes the remaining delay will be displayed and the corresponding LED will flash:
Once the set delay is complete the flashing LED will turn off and the programme set will start.
Cycle phase under way
During the wash cycle the LEDs gradually illuminate on to indicate the cycle phase under way:
Note
•
During draining the LED corresponding to the Spin cycle phase will be turned on.
•
When the drying cycle is complete the indicator light relative to phase will flash to indicate that the DRYING
knob needs to be set back to the 0 setting.
Function Buttons
The FUNCTION BUTTONS also act like LEDS. When a function is selected the corresponding button is
illuminated.
To Next Page
Loading...
