SCM2 test procedure
MODEL TEST PROCEDURE
ICON AND ASSOCIATED
DISPLAY
Icon
NOTES
Display Unit
Scholtès Touch Super Vapour
DISPLAY
TEST
MODE
With the machine on stand-
by (off but with the main
on/off switch set to I), open
the service door and press
and hold the 1 CUP,
STRENGTH and MENU
keys at the same time for at
least 6 seconds, or until the
message “SELECT TEST”
appears on the display.
After this, shut the service
door and press the 1 CUP
icon: all digits will light up
on the display followed by
the words “DISPLAY TEST
MODE”.
1 cup
2 cups
Steam
Long/short
STRENGTH
Down Menu
Key Lock
MENU
UP menu
OK
Hot water
On/Stand by
BUTTON 1
BUTTON 2
BUTTON 4
BUTTON 9
BUTTON 10
BUTTON 8
BUTTON 12
BUTTON 11
BUTTON 6
BUTTON 7
BUTTON 5
BUTTON 0
When not used for
10 seconds, the
machine exits test
mode. The original
language is reset and
the first priming
enabled.
To Next Page
Loading...