Indian Motorcycle Ride Command - Page 34

MMAAPP AANNDD PPOOIINNTT OOFF IINNTTEERREESSTT UUPPDDAATTEESS
For Map and Point of Interest updates, a 32GB or larger USB drive
is required (USB 3.0 drive is highly recommended). USB drive must
be formatted to exFAT® before copying files onto it.
NOTICE
A USB 2.0 or USB 3.0 flash drive formatted to exFAT® is required
to successfully perform an update. The display will not recognize
flash drives that do not meet this requirement.
IMPORTANT
Do not remove power from the display during the update
process.
OOVVEERR TTHHEE AAIIRR UUPPDDAATTEESS
NOTICE
Over the air updates are only available on models equipped with
a cell modem.
If your model is equipped with a cell modem, the motorcycle will
automatically download software updates from the cloud when the
motorcycle is powered on and a cell modem connection is
available. All downloads occur in the background and can be
resumed if the connection is interrupted or if the motorcycle is
turned off.
HHOOWW TTOO IINNSSTTAALLLL SSOOFFTTWWAARREE
Once new software has been downloaded to your display, you will
be prompted with a notification.
To install new software, do the following:
1. Navigate to the General Settings tab in the Settings menu.
2. Press the “Install” button.
NOTICE
The following conditions must be met for the installation to
initiate: the battery voltage must be greater than 12.5 V, the
wheel speed must be at 0 mph, and the RPMs must equal 0.
NOTICE
The display will restart after the installation has successfully
completed.
NOTICE
Critical updates will be installed automatically. A notification will
display once the update is compete.
3. After the update had been completed, release notes will be
provided on the software update screen.
32
MAINTENANCE