Indmar Marine Engines
xi
Lubricant – Indmar uses and recommends
Pennzoil 15W40 Marine Oil for use in all of its
engines except for the 8.1 liter models which use
Pennzoil 40W oil. If Pennzoil Marine oil is not
available, any appropriate viscosity motor oil
meeting the API ratings of SL/SJ, CI-4, CH-4,
CG-4 is acceptable. See Chapter 6, Maintenance,
for information regarding the use of synthetic oil.
Additives – The only additive that is recommended by
Indmar for use in your engine is Sta-Bil brand fuel sta-
bilizer. This additive helps preserve the fuel in your
tank and in the engine’s fuel system. We recommend
the use of Sta-Bil during off-season storage and for the
boater that consumes less than a full tank of fuel every
two weeks. See Chapter 5, Fuel, for more information.
Emissions Components Warranty
The following components are considered as part of the
emissions control system and are covered under the
Emissions Control Warranty.
1. Fuel Metering System
A. Fuel injectors
B. Fuel pressure regulator
C. Manifold Absolute Pressure Sensor
D. Throttle Position Sensor
E. Idle Air Control Valve
F. Throttle Body – Port Fuel Injection Models
G. Throttle Body Assembly – Throttle Body Fuel
Injection Models
H. Carburetor
I. Coolant Temperature Sensor
J. Intake Valves
K. Oxygen Sensors
2. Air Induction System
A. Intake Manifold
B. Air Filter (Flame Arrestor)
3. Ignition System
A. Spark Plugs
B. Electronic Ignition System
C. Ignition coil and/or control module
D. Ignition Wires
4. Lubrication System
A. Oil pump and internal parts
5. Positive Crankcase Ventilation (PCV) System
A. PCV valve
B. Oil Filler Cap
6. Exhaust System
A. Exhaust manifold(s)
B. Exhaust riser(s)
C. Exhaust valves
D. Catalytic Converters
7. Miscellaneous Items Used on Above Systems
A. Hoses, clamps, fittings, tubing, sealing gaskets or
devices and mounting hardware
B. Electronic Controls
C. Electronic Control Module
D. Pulleys, belts and idlers
OME0502-07 Body.qxd 6/14/06 10:38 AM Page xi
To Next Page
Loading...
Need help?
General