4-4
Indmar Marine Engines
FUEL SYSTEM
The Indmar fuel system uses high quality marine grade
components. These components will tolerate small
amounts of water without sustaining damage. Your
engine will misfire and run poorly, however, if water is in
the fuel. Use caution when re-fueling not to allow water
to enter the fuel system. If you suspect your fuel is water
contaminated, consult your dealer and avoid that fuel
source in the future.
Do not attempt to repair or replace any compo-
nents of the fuel system. They are special
marine parts and may require special service
tools. You could damage the fuel system by
not using specified tools. This could cause a
fire or explosion and subsequent death or seri-
ous personal injury to you or your passengers.
See your dealer for assistance with fuel system repairs.
BATTERY
Your engine uses a special 12-volt marine battery. If a
replacement is needed, use only a marine battery with
minimum 650 cold cranking amps at 0° F (-18° C).
Before disconnecting the battery, make sure the battery
switch (if equipped), ignition key and all accessories are
in the OFF position.
Be sure to connect cables properly:
• Black cable to the negative or (-) post
• Red cable to the positive or (+) post
Figure 4.4 – Typical Marine Battery
INDM-A010
OME0502-07 Body.qxd 6/14/06 10:38 AM Page 4-4
To Next Page
Loading...
Need help?
General