Indmar Marine Engines
3-3
Figure 3.3 – Typical Tachometer
Once the engine has started, immediately
check the oil pressure. Monitor the oil pres-
sure and engine temperature closely for the
first 10 minutes of operation.
IF ENGINE DOES NOT START
Do not operate starter motor for more than
15 seconds without a 2 (two) minute cool-
down period. Excessively long cranking
times will permanently damage the starter
motor and drain the battery. Damage from
overheating the starter motor is not covered
by the warranty.
Hold key in START position for 3-5 seconds. If engine
still does not start, advance throttle lever about 1/4 of its
total travel. Turn key and hold it there for 12 more sec-
onds until engine starts.
If your engine does not start after several attempts, it
may have too much fuel and needs to be cleared.
HOW TO CLEAR THE ENGINE
1. Check throttle lever (2, Figure 3-4) to make sure it is
pulled out (or shift interlock button, 1, activated) so
that boat is still in NEUTRAL.
2. Wait for 30 seconds to allow starter motor to cool.
rpm
INDM-A013
1
2
3
4
5
6
0
OME0502-07 Body.qxd 6/14/06 10:38 AM Page 3-3
To Next Page
Loading...
Need help?
General