Indmar Marine Engines
7-5
6. On Ski-Vee equipped units, the hoses that are con-
nected to the integral V-Drive cooler (1, Figure 7.4)
must be removed to drain the hoses and cooler. The
anodes (2, Figure 7.4) at the back of the cooler must
be removed and inspected. Replace if they are 50%
eroded.
Figure 7.4 – Ski-Vee
Figure 7.5 – Walter V-Drive Drain Plugs
NOTICE
Placing all drain plugs, impeller, etc. in a plastic bag
and attaching the bag to the steering wheel of the
boat is a good reminder to reinsert the plugs when
you recommission the boat in the spring.
WATER LINE
WATER
DRAIN
WATER DRAIN
INDM-A040
INDM-A041
1
2
2
1
OME0502-07 Body.qxd 6/14/06 10:38 AM Page 7-5