INETVU® MOBILE SYSTEM QUICK START – HUGHES KA
1.12 Software Installation and Configuration
Please Note: Do not connect the Controller via USB until the drivers and software have
been installed
1. If you are installing from the USB flash drive or have downloaded from the C-COM FTP/KB,
extract the contents of the ZIP file and run iNetVu7000Setup.exe.
2. Install the iNetVu 7000 Software and close when complete.
3. Install both the FTDI USB Driver and USB Driver. Exit the Wizard when complete.
4. Now connect the Controller to the PC using the provided USB cable.
5. Ensure the software is running as Administrator.
6. You can now run the iNetVu Mobile 7000 software from the shortcut on your desktop.
To Next Page
Loading...
Need help?
General
