INETVU® MOBILE SYSTEM QUICK START – HUGHES KA
1.3 Pre-Configuration Check List
The following items should be completed/known prior to configuring the iNetVu® Mobile System.
Contact the Network Operation Center (NOC) or ISP if any of the following items are unknown or if
you are unfamiliar with them.
Note: Please contact C-COM if you require more information about modem compatibility as these
may change without further notice.
• IP Address Satellite Modem
• Satellite Coordinate
• DVB Parameters
• Verify Modem Firmware Version is correct with minimal 6.10.0.19 and that the CFG file has only
1 LNB setting in the file. The CFG file and or any other changes must be requested and provided
by the NOC.
Note: CFG file must include SWAP command “InstallationMode=6” this will allow the SWAP
command to work properly and modem signal will be displayed in iNetVu software.
9200/9400 Series
The HN9200 is a dual band Ka/Ku/Ex C-band broadband indoor unit. The HN9200
incorporates advanced modulation to deliver high speed connectivity for bandwidth intensive
applications at an affordable price. The HN9400 is a new generation dual Ka/Ku/Ex C-band
satellite router that incorporates advanced LDPC coding allowing for high throughput
bandwidth. HN9400 supports upstream burst rates of 3.2 Mbps.
9600/9800 Series
The HN9600 modem is a Ka-band high performance satellite router with a single Intra Facility
Link (IFL) cable, while the HN9800 is a new generation broadband router designed for high
throughput satellite applications which incorporate advanced LDPC coding and other
advanced features. The HN9800 features a single IFL interface link to the outdoor unit
providing high performance DVBS2 channels.
See Hughes Manuals for more info and modem specifications.
To Next Page
Loading...
Need help?
General
