19.
Keeping one hand on the baby, drape the
“shoulder straps” over the back of the chair.
4.
Feed the “shoulder strap” down the back of
the chair, between the back legs and under the
seat. Thread the strap through the underneath
side of the chair up to the “lower shoulder
buckle” on the same side.
5.
Keep one hand on your baby while
you fasten the “shoulder strap” to the
“lower shoulder strap buckle” on the body of
the carrier near the baby’s leg. You will hear
a ‘click’ when the buckle is locked in position.
Make the strap snug by pulling the “shoulder
strap end.”
6.
With the baby facing forward, place the baby
in a seated, upright position on the chair,
centered with his/her back against the back
of the chair.
3.
* IMPORTANT! Keep one hand on the baby until all
buckles and straps are properly fastened.
* NOTE: If you are converting to this application from either 1 Facing-in or 3
Backpack positions, the “shoulder strap” will have a half twist in it when it is
properly secured. Though not at all necessary, you can remove the twist by
(1) unfastening the “shoulder strap/child restraint buckle,” (2) giving the
padded end of the “shoulder strap” a half twist in the correct direction, and
(3) reconnecting the buckle. If you intend to return to either position 1 or
position 3 after using the carrier for this application, please leave the half
twist in the strap.
To Next Page
Loading...
