Infasecure 527 - Hook the Rear Straps Onto the Knobs Found at the Rear of the Seat [Figure

6. Secure the seat to the ‘A’ frame by
sliding the axle rod through the seat
support and aligned seat [Figure 6].
Attach nuts to each end to hold the
rod in place.
7. To attach the basket loop the clip
straps over the seat locking bar located
under the seat [Figure 7].
8. Hook the rear straps onto the knobs
found at the rear of the seat [Figure 8].
9. To install the footrest (E) simply push it
into position using the slots provided
on the seat and the back of footrest
[Figure 9].
Figure 6
Figure 7
Figure 8
Figure 9
5