10 Installation and removal
5 Installation and removal
5.1 Mount the bus module on the DIN-TS35 top hat rail
1 Hook unit on top hat rail at bottom.
2 Press unit onto top hat rail at top.
5.1.1 Establish connections
Connect the bus module with the leak detector
The bus module communicates via data cable with the leak detector and is supplied
with voltage by the data cable.
INFICON data cable
1 Connect bus module (connection LD) via data cable with the leak detector.
2 Connect the bus module with the external controller by means of the built-in
fieldbus module.
The bus module is activated in the leak detector, e.g. the MSB box of the LDS3000,
see leak detector manual.
Communication with fieldbus master
► Information about establishing communication with the fieldbus master: see
interface protocols, jira54 and kirb43.
Fig. 2 Mounting of bus module
To Next Page
Loading...