6 Safety
2Safety
2.1 Intended use
The bus module is a device interface between e.g. the MSB box of the mass
spectrometer module LDS3000 and an external controller.
► Install, operate and service the unit only in compliance with these instructions.
► Comply with the limits of application (see chapter 4.2, page 8).
2.2 Owner requirements
Safety conscious operation
► Operate and install the unit only if it is in perfect working order and as intended,
in a safety-conscious manner and fully aware of dangers, in compliance with
these instructions.
► Fulfill and ensure compliance with the following regulations:
– Intended use
– Generally applicable safety and accident prevention regulations
– International, national and local standards and guidelines
– Additional provisions and regulations that are specific to the unit
► Use only original parts or parts approved by the manufacturer.
► Keep this manual available at the operating site.
Personnel qualifications
► All work must be performed only by technical specialists who have been trained
on the unit.
► Allow personnel in training to work with the unit only under the supervision of
technical specialists.
► Make sure that the authorized personnel have read and understood these
instructions and all other applicable documents (see chapter 1.2, page 4),
especially the information on safety, maintenance and repairs, before starting
work.
► Define responsibilities, authorizations and supervision of personnel.
2.3 Operator requirements
► Read, observe and follow the information in these instructions and the working
instructions created by the owner, especially the safety instructions and warnings.
► Perform all work based on the complete instructions.
To Next Page
Loading...