What to do if Inficon Control Unit shows 'WWATCHDOG EERROR I'?
If the Inficon Control Unit displays 'WWATCHDOG EERROR I', it could be due to the unit being turned on too quickly after being powered off, or the watchdog tripping because of a severe electrical disturbance or an operating system error. In either case, acknowledge the error with the key.
What to do if Inficon Control Unit displays 'DDATA CORRUUPTED I'?
If the Inficon Control Unit shows 'DDATA CORRUUPTED I', this indicates a parameter memory error (EEEPROM). Acknowledge the error with the key.
What to do if Inficon Control Unit displays 'SSENSOR ERRROR I'?
If the Inficon Control Unit displays 'SSENSOR ERRROR I', this indicates an interruption or instability in the sensor line or connector. Acknowledge the error with the key.
General| Brand | Inficon |
|---|---|
| Model | VGC502 |
| Category | Control Unit |
| Language | English |
Specifies required qualifications for personnel.
General safety precautions and guidelines.
Initial steps for setting up the device.
Instructions for installing VGC501 in a rack.
Instructions for installing VGC502 and VGC503 in a rack.
Steps for mounting the unit in a control panel.
Information on connecting the main power supply.
Details on connecting gauges to channels.
Details of the control connector for VGC501.
Details of the control connector for VGC502/503.
Details of the relay connector for VGC502/503.
Overview of the device's front panel components.
Procedures for powering the unit on and off.
Description of various operational modes.
Details on how the device displays measurements.
Navigating and managing device parameters.
Configuring switching functions and thresholds.
Settings and parameters for connected gauges.
Managing gauge activation and deactivation.
Connecting and communicating via USB Type B.
Connecting and communicating via Ethernet.
Retrieving error status information.
Resetting the device or error status.
Configuring switching functions and thresholds.
Controlling individual gauges.
Configuring Ethernet network settings.
Interpreting error messages and signals.
Procedures for updating the device firmware.
Update via USB Type A.
Update via USB Type B Update Tool.
Steps to connect the unit to a network.
Connecting the unit to a computer via Ethernet.
To Next Page
