Need help?Do you have a question about the InfiNet R5000 series and is the answer not in the manual?
Explains the manual's structure and chapter overview.
Lists and defines abbreviations used throughout the document.
Describes caution and note symbols used in the document.
Introduces the Web interface as a management tool and its capabilities.
Details how to access the R5000 unit via the Web interface.
Displays main unit parameters in real-time, with auto-refresh options.
Gathers complete information and enhanced statistics for each unit interface.
Gathers complete and enhanced statistics for each switch group.
Allows configuration of R5000 series units via Web interface or Command-line.
Performs service tasks like firmware upgrades and system checks.
Performs deep analysis of radio emissions in the environment.
Provides monitoring and management of the DFS operation.
Emulates CLI in the Web interface for device management.
Provides step-by-step instructions for basic R5000 unit configurations.
Guides through configuring two R5000 units for a Point-to-Point link.
Separates management traffic from data traffic using VLANs and switch groups.
Sets up VLAN filters for BS to CPE traffic separation and management.
Enables SNMP agent and creates an SNMPv3 account for network monitoring.
Sets up multiple radio profiles on a CPE for switching between base stations.
General| IP Rating | IP67 |
|---|---|
| Channel Width | 5, 10, 20, 40 MHz |
| Security | AES-128 |
| Operating Temperature | -40°C to +60°C |
| Interface | Ethernet (RJ-45) |
To Next Page
